Opel Omega

since 1993-1999 of release

Repair and car operation


Opel Omega
+ 1. Maintenance instruction
+ 2. Maintenance
- 3. Repair of engines
   + 3.1. SOHC engines in volume 2,0 liters
   + 3.2. DOHC engines in volume 2,0 liters
   - 3.3. Engines in volume 2,5 and 3,0 liters
      3.3.1. Technical characteristics
      3.3.2. Compression check
      3.3.3. Top dead point (VMT) of the N1 piston
      3.3.4. Covers of camshafts
      3.3.5. Pulley of a cranked shaft
      3.3.6. Covers of a gas-distributing belt
      3.3.7. Gas-distributing belt
      3.3.8. Natyazhitel of a belt, asterisks and intermediate pulleys
      3.3.9. Epiploons of camshafts
      3.3.10. Camshafts and pushers
      3.3.11. Head of cylinders
      3.3.12. Oil pallet
      3.3.13. Oil pump
      3.3.14. Oil radiator
      3.3.15. Flywheel and leading disk
      3.3.16. Epiploons of a cranked shaft
      3.3.17. Engine and transmission fastenings
   + 3.4. Partition of all petrol engines
   + 3.5. Diesel engine in volume 2,0 liters
   + 3.6. Diesel six-cylinder 2,5-liter engine
+ 4. Heating system and ventilation
+ 5. Fuel, exhaust systems
+ 6. System of start of the engine
+ 7. Ignition system
+ 8. Coupling
+ 9. Transmissions
+ 10. Main transfer, semi-axes
+ 11. Brake system
+ 12. Suspension bracket and steering
+ 13. Body
+ 14. Body electric equipment



3.3.17. Engine and transmission fastenings

Check
PERFORMANCE ORDER
1. Lift and fix a forward part of the car.
2. Examine rubber shock-absorbers of support on existence of wear and damages, if necessary, replace them.
3. Check, that bolts of support were strong tightened.
4. Check, whether support are worn-out.

Replacement

PERFORMANCE ORDER
Left and right support of the engine
1. Lift and fix a forward part of the car.
2. Establish a jack under the engine and a transmission or fix the engine on the lift.
3. Unscrew bolts and remove shock-absorbers. Braid the nuts, fixing support to an arm of the block of cylinders and a body (the nut is specified by an arrow).
4. Remove support. If necessary remove also an arm.
5. Examine support on existence of wear and damages and, if necessary, replace them.
6. Establish support upside-down.
Back fastening of a transmission
7. Lift and fix a forward part of the car.
8. Establish a jack under a transmission.
9. Unscrew the bolts fixing to a body a cross-piece of a back support of a transmission. Braid nuts fixing a support to a cross-piece and remove a cross-piece.
10. Unscrew bolts and remove a support.
11. Examine a support on existence of wear and damages and, if necessary, replace it.
12. Establish a support in return sequence.