Opel Omega

since 1993-1999 of release

Repair and car operation



Opel Omega
+ 1. Maintenance instruction
+ 2. Maintenance
- 3. Repair of engines
   + 3.1. SOHC engines in volume 2,0 liters
   + 3.2. DOHC engines in volume 2,0 liters
   - 3.3. Engines in volume 2,5 and 3,0 liters
      3.3.1. Technical characteristics
      3.3.2. Compression check
      3.3.3. Top dead point (VMT) of the N1 piston
      3.3.4. Covers of camshafts
      3.3.5. Pulley of a cranked shaft
      3.3.6. Covers of a gas-distributing belt
      3.3.7. Gas-distributing belt
      3.3.8. Natyazhitel of a belt, asterisks and intermediate pulleys
      3.3.9. Epiploons of camshafts
      3.3.10. Camshafts and pushers
      3.3.11. Head of cylinders
      3.3.12. Oil pallet
      3.3.13. Oil pump
      3.3.14. Oil radiator
      3.3.15. Flywheel and leading disk
      3.3.16. Epiploons of a cranked shaft
      3.3.17. Engine and transmission fastenings
   + 3.4. Partition of all petrol engines
   + 3.5. Diesel engine in volume 2,0 liters
   + 3.6. Diesel six-cylinder 2,5-liter engine
+ 4. Heating system and ventilation
+ 5. Fuel, exhaust systems
+ 6. System of start of the engine
+ 7. Ignition system
+ 8. Coupling
+ 9. Transmissions
+ 10. Main transfer, semi-axes
+ 11. Brake system
+ 12. Suspension bracket and steering
+ 13. Body
+ 14. Body electric equipment




3.3.15. Flywheel and leading disk

Removal

PERFORMANCE ORDER
Mechanical transmission
1. Remove a transmission and coupling.
2. Stop a flywheel and note its correct adjusting arrangement.
3. Unscrew bolts and remove a flywheel.
Automatic transmission
4. Remove a transmission.
5. Stop a leading disk and weaken its bolts.
6. Completely unscrew bolts and remove a leading disk.

Check

Check a flywheel on existence of wear and damages. At detection of those, address to the expert.

Installation

PERFORMANCE ORDER
Mechanical transmission
1. Clean being joined surfaces of a flywheel and a cranked shaft. Clean carvings of bolts.
2. Establish a flywheel, insert and tighten bolts.
3. Establish coupling and a transmission.
Automatic transmission
4. Clean being joined surfaces of a leading disk and a cranked shaft. Clean carvings of bolts.
5. Establish a leading disk and tighten bolts.