Opel Omega

since 1993-1999 of release

Repair and car operation

Opel Omega
+ 1. Maintenance instruction
+ 2. Maintenance
- 3. Repair of engines
   - 3.1. SOHC engines in volume 2,0 liters
      3.1.1. Technical characteristics
      3.1.2. Compression check
      3.1.3. Top dead point (VMT) of the N1 piston
      3.1.4. Camshaft cover
      3.1.5. Pulley of a cranked shaft
      3.1.6. Covers of a gas-distributing belt
      3.1.7. Gas-distributing belt
      3.1.8. Natyazhitel of a gas-distributing belt and asterisk
      3.1.9. Camshaft epiploon
      3.1.10. Casing of a camshaft and camshaft
      3.1.11. Pushers and hydraulic lifts
      3.1.12. Head of cylinders
      3.1.13. Oil pallet
      3.1.14. Oil pump
      3.1.15. Flywheel
      3.1.16. Epiploons of a cranked shaft
      3.1.17. Engine and transmission fastenings
   + 3.2. DOHC engines in volume 2,0 liters
   + 3.3. Engines in volume 2,5 and 3,0 liters
   + 3.4. Partition of all petrol engines
   + 3.5. Diesel engine in volume 2,0 liters
   + 3.6. Diesel six-cylinder 2,5-liter engine
+ 4. Heating system and ventilation
+ 5. Fuel, exhaust systems
+ 6. System of start of the engine
+ 7. Ignition system
+ 8. Coupling
+ 9. Transmissions
+ 10. Main transfer, semi-axes
+ 11. Brake system
+ 12. Suspension bracket and steering
+ 13. Body
+ 14. Body electric equipment

3.1.17. Engine and transmission fastenings

Check

PERFORMANCE ORDER

1. Lift and fix a forward part of the car.

2. Examine rubber shock-absorbers of support on existence of wear and damages, if necessary replace them.

3. Check, that bolts of support were strong tightened.

4. Check, whether support are worn-out.

Replacement

LEFT AND RIGHT SUPPORT OF THE ENGINE

PERFORMANCE ORDER

1. Lift and fix a forward part of the car.

2. Establish a jack under the engine and a transmission or fix the engine on the lift.

3. Braid the nuts, fixing support to an arm of the block of cylinders and a body. Remove support. If necessary remove also an arm.

4. Examine support on existence of wear and damages and, if necessary, replace them.

5. Establish support upside-down.

BACK FASTENING OF THE TRANSMISSION

PERFORMANCE ORDER

1. Lift and fix a forward part of the car.

2. Establish a jack under a transmission.

3. Unscrew the bolts fixing to a body a cross-piece of a back support of a transmission. Braid nuts fixing a support to a cross-piece and remove a cross-piece.

4. Unscrew bolts and remove a support.

5. Examine a support on existence of wear and damages and, if necessary, replace it.

6. Establish a support in return sequence.