Opel Omega

since 1993-1999 of release

Repair and car operation

Opel Omega
+ 1. Maintenance instruction
+ 2. Maintenance
- 3. Repair of engines
   - 3.1. SOHC engines in volume 2,0 liters
      3.1.1. Technical characteristics
      3.1.2. Compression check
      3.1.3. Top dead point (VMT) of the N1 piston
      3.1.4. Camshaft cover
      3.1.5. Pulley of a cranked shaft
      3.1.6. Covers of a gas-distributing belt
      3.1.7. Gas-distributing belt
      3.1.8. Natyazhitel of a gas-distributing belt and asterisk
      3.1.9. Camshaft epiploon
      3.1.10. Casing of a camshaft and camshaft
      3.1.11. Pushers and hydraulic lifts
      3.1.12. Head of cylinders
      3.1.13. Oil pallet
      3.1.14. Oil pump
      3.1.15. Flywheel
      3.1.16. Epiploons of a cranked shaft
      3.1.17. Engine and transmission fastenings
   + 3.2. DOHC engines in volume 2,0 liters
   + 3.3. Engines in volume 2,5 and 3,0 liters
   + 3.4. Partition of all petrol engines
   + 3.5. Diesel engine in volume 2,0 liters
   + 3.6. Diesel six-cylinder 2,5-liter engine
+ 4. Heating system and ventilation
+ 5. Fuel, exhaust systems
+ 6. System of start of the engine
+ 7. Ignition system
+ 8. Coupling
+ 9. Transmissions
+ 10. Main transfer, semi-axes
+ 11. Brake system
+ 12. Suspension bracket and steering
+ 13. Body
+ 14. Body electric equipment

3.1.13. Oil pallet

Removal

PERFORMANCE ORDER

1. Disconnect a wire of the minus plug of the accumulator.

2. Lift and fix a forward part of the car.

3. Merge engine oil and tighten a cap of a drain opening.

4. Disconnect a wire from the sensor on the oil pallet.

5. Unscrew bolts of basic arms of a casing of a transmission and the block of cylinders. Remove both arms and remove the bottom cover of a flywheel.

6. Braid nuts of the left and right support of the engine, remove an arm of the right support.

7. Fix the engine on the lift.

8. Unscrew bolts of the oil pallet and remove the pallet.

9. Remove a maslozaborny branch pipe and a dividing partition of the pallet.

Installation

PERFORMANCE ORDER

1. Carefully clean being joined surfaces of the pallet, the block of cylinders and the oil pump. Clean bolts of the pallet and a maslozaborny branch pipe.

2. Put hermetic N15 03 295 on being joined surfaces of the block of cylinders.

3. Put hermetic N15 10 181 on carvings of bolts of a maslozaborny branch pipe.

4. Establish a dividing partition and tighten bolts of a maslozaborny branch pipe.

5. Put hermetic on carvings of bolts of the pallet, establish the pallet and tighten bolts.

6. Establish the remained details.