Opel Omega
+ 1. Maintenance instruction
+ 2. Maintenance
- 3. Repair of engines
+ 3.1. SOHC engines in volume 2,0 liters
+ 3.2. DOHC engines in volume 2,0 liters
+ 3.3. Engines in volume 2,5 and 3,0 liters
+ 3.4. Partition of all petrol engines
+ 3.5. Diesel engine in volume 2,0 liters
- 3.6. Diesel six-cylinder 2,5-liter engine
3.6.1. Removal and engine installation
3.6.2. Head of cylinders
3.6.3. Cam-shaft
3.6.4. Compression check
3.6.5. Multiridge maple belt
3.6.6. Pallet of a case and laying
- 3.6.7. System of cooling of the diesel engine of 2,5 liters
3.6.7.1. Thermostat
3.6.7.2. Radiator
3.6.7.3. The fan with vyazkostny the fan coupling / coupling
3.6.7.4. Cooling pump
3.6.7.5. Pipe of the airsupercharger
+ 4. Heating system and ventilation
+ 5. Fuel, exhaust systems
+ 6. System of start of the engine
+ 7. Ignition system
+ 8. Coupling
+ 9. Transmissions
+ 10. Main transfer, semi-axes
+ 11. Brake system
+ 12. Suspension bracket and steering
+ 13. Body
+ 14. Body electric equipment
|
Arrangement of elements of system of cooling
|
1. Cover
2. Compensatory tank
3. Gate of system of a heater
4. Heater heat exchanger
5. Returnable pipeline
cooling liquid
6. The submitting pipeline
cooling liquid
7. Block of cylinders
|
8. The submitting pipeline of cooling liquid of a radiator
9. Water pump
10. Additional pump
11. Radiator
12. The returnable pipeline of cooling liquid of a radiator
13. Head of cylinders
14. Hose of removal of air |
THERMOSTAT
Removal
| PERFORMANCE ORDER |
| The car without the conditioner |
| 1. Merge cooling liquid in a vessel. |
Prevention
To merge cooling liquid completely it is not required. Enough that level of liquid was lower than the thermostat case.
|
| 2. Unscrew the top casing of the engine and a pipe for air forcing. |
| The car with the conditioner |
| 3. Unscrew the fan with the vyazkostny coupling. |
|
4. Unscrew a pipe (1) heater on the case of a drive of a camshaft. |
| 5. Unscrew and remove the case with the thermostat. |
| 6. Remove consolidation from the thermostat case. |
|
Installation
| PERFORMANCE ORDER |
| 1. Clear a surface adjoining to consolidation. |
| 2. Replace the thermostat together with the case. |
|
3. Establish new consolidation in the thermostat case, establish the thermostat in the case. Thus the gate (2) for production of air should get in directing (1). |
| 4. Screw the thermostat case with effort of 10 N of m. |
| 5. Screw a heater pipe on the case of a drive of a camshaft. |
| 6. Establish a pipe for forcing of air and an engine casing. |
| 7. Check antifrizny properties of cooling liquid, add cooling liquid and pump over cooling system. |
|
|
|