Opel Omega
+ 1. Maintenance instruction
+ 2. Maintenance
- 3. Repair of engines
+ 3.1. SOHC engines in volume 2,0 liters
- 3.2. DOHC engines in volume 2,0 liters
3.2.1. Technical characteristics
3.2.2. Compression check
3.2.3. Top dead point (VMT) of the N1 piston
3.2.4. Cover of camshafts
3.2.5. Pulley of a cranked shaft
3.2.6. Covers of a gas-distributing belt
3.2.7. Gas-distributing belt
3.2.8. Natyazhitel of a belt, asterisks and intermediate pulleys
3.2.9. Epiploons of camshafts
3.2.10. Camshafts and pushers
3.2.11. Head of cylinders
3.2.12. Oil pallet
3.2.13. Oil pump
3.2.14. System of an equilibration of a cranked shaft (engines since 1998)
3.2.15. Flywheel
3.2.16. Epiploons of a cranked shaft
3.2.17. Engine and transmission fastenings
+ 3.3. Engines in volume 2,5 and 3,0 liters
+ 3.4. Partition of all petrol engines
+ 3.5. Diesel engine in volume 2,0 liters
+ 3.6. Diesel six-cylinder 2,5-liter engine
+ 4. Heating system and ventilation
+ 5. Fuel, exhaust systems
+ 6. System of start of the engine
+ 7. Ignition system
+ 8. Coupling
+ 9. Transmissions
+ 10. Main transfer, semi-axes
+ 11. Brake system
+ 12. Suspension bracket and steering
+ 13. Body
+ 14. Body electric equipment
|
Removal
| PERFORMANCE ORDER |
|
|
1. Disconnect ventilating hoses from a cover of camshafts. |
|
|
| 2. Unscrew bolts and uncover spark plugs (drawing at the left), disconnect wires from candles (drawing on the right). |
| 3. Weaken a nut and remove the holder of a plait of wires in the top part of a cover of a gas-distributing belt. |
| 4. Disconnect a wire from the sensor of a camshaft and from a cover of camshafts. |
| 5. Unscrew bolts of a cover of camshafts. |
| 6. Uncover also laying, if necessary replace laying. |
|
Installation
| PERFORMANCE ORDER |
| 1. Carefully examine and clean being joined surfaces of a cover and a head of cylinders. Establish laying. |
| 2. Put hermetic N15 03 295 on a surface of a head of cylinders round covers of forward bearings of camshafts and in semicircular cuts in a back part of a head. |
| 3. Establish a cover, insert and tighten bolts. |
| 4. Establish the remained details. |
|
|
|