Opel Omega

since 1993-1999 of release

Repair and car operation



Opel Omega
+ 1. Maintenance instruction
+ 2. Maintenance
- 3. Repair of engines
   + 3.1. SOHC engines in volume 2,0 liters
   + 3.2. DOHC engines in volume 2,0 liters
   + 3.3. Engines in volume 2,5 and 3,0 liters
   - 3.4. Partition of all petrol engines
      3.4.1. Technical characteristics
      3.4.2. Compression check
      - 3.4.3. Engine partition
         3.4.3.1. Major maintenance of the engine
         3.4.3.2. Engine diagnostics by means of the vacuum gage
         3.4.3.3. Compression check in engine cylinders
         3.4.3.4. Major maintenance of the engine - alternatives 3_4_3_5.htm
         3.4.3.6. Block of cylinders of an incomplete complete set
         3.4.3.7. Repair engine (block of cylinders of a full complete set)
      3.4.4. Auxiliary elements of the engine
      + 3.4.5. Engine
      3.4.6. Engine partition
      3.4.7. Head of cylinders and valves
      3.4.8. Pistons and rods
      3.4.9. Cranked shaft
      3.4.10. Block of cylinders
      3.4.11. Radical bearings and bearings of rods
      3.4.12. Piston rings
      3.4.13. The first start of the engine after a partition
   + 3.5. Diesel engine in volume 2,0 liters
   + 3.6. Diesel six-cylinder 2,5-liter engine
+ 4. Heating system and ventilation
+ 5. Fuel, exhaust systems
+ 6. System of start of the engine
+ 7. Ignition system
+ 8. Coupling
+ 9. Transmissions
+ 10. Main transfer, semi-axes
+ 11. Brake system
+ 12. Suspension bracket and steering
+ 13. Body
+ 14. Body electric equipment


3.4.3.6. Block of cylinders of an incomplete complete set

GENERAL INFORMATION

The block of cylinders of an incomplete complete set contains the block of cylinders with established by the krivoshipno-shatunny mechanism and piston group. All interfaced details are picked up for the dimensional groups, all gaps correspond to norms. On the block the cam-shaft, the klapanny mechanism, a head of the block of cylinders and hinged units are separately mounted not a part of it ремкомплекта. Costs of machining are minimum or are not required absolutely.