Opel Omega
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Repair of engines
+ 4. Heating system and ventilation
+ 5. Fuel, exhaust systems
+ 6. System of start of the engine
+ 7. Ignition system
+ 8. Coupling
+ 9. Transmissions
+ 10. Main transfer, semi-axes
- 11. Brake system
11.1. Technical characteristics
11.2. Brake overlays of forward brakes
11.3. Brake overlays of back brakes
11.4. Support of a forward brake
11.5. Support of a back brake
11.6. Brake disk
11.7. Brake shoes of the hand brake
11.8. Rope of the hand brake
11.9. Lever of the hand brake
11.10. Main brake cylinder
11.11. Tank of brake liquid and sensor of level of liquid
11.12. Pumping of brake system
11.13. Hydraulic tubes and hoses
11.14. Vacuum hose and valve of the vacuum amplifier of brakes
11.15. Vacuum amplifier
11.16. Brake pedal
11.17. System of anti-blocking of brakes / protivobuksovochny system
+ 12. Suspension bracket and steering
+ 13. Body
+ 14. Body electric equipment
|
Survey
| PERFORMANCE ORDER |
| Examine brake overlays for existence of wear and measure their thickness by means of a ruler. If any of brake slips demands replacement, it is necessary to replace all four brake slips on both wheels together with antinoise slips. |
|
Removal
| PERFORMANCE ORDER |
|
1. Beat out the top fixing pin of antinoise springs. |
|
2. Remove an antinoise spring. |
|
3. Beat out the bottom pin. |
|
|
| 4. By means of flat-nose pliers or the special tool dissolve brake slips a little in the parties. |
|
5. Remove brake slips. |
|
Installation
Installation is carried out to sequences, return to removal.
Check
| PERFORMANCE ORDER |
|
1. Lower pistons deep into a support. |
|
2. Check, that cuts on pistons were turned down approximately at an angle in 23 ° in a horizontal. |
|
3. Grease a return surface of slips with high-temperature greasing. |
|
4. Establish into place fixing pins. |
|
|
|