Opel Omega

since 1993-1999 of release

Repair and car operation

Opel Omega
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Repair of engines
+ 4. Heating system and ventilation
- 5. Fuel, exhaust systems
   + 5.1. Petrol engines
   - 5.2. Diesel engine in volume 2,0 liters
      5.2.1. Technical characteristics
      5.2.2. Air filter and air inlet channels
      5.2.3. Accelerator pedal
      5.2.4. Filling and pumping of fuel system
      5.2.5. Fuel level sensor
      5.2.6. Fuel tank
      5.2.7. Check and adjustment of the maximum turns
      5.2.8. Electric knots of system of injection
      5.2.9. Fuel pump of a high pressure
      5.2.10. Moment of injection of fuel
      5.2.11. Fuel nozzles
      5.2.12. Turbonagnetatel
      5.2.13. Inlet collector
      5.2.14. Final collector
   + 5.3. Diesel V6 2,5-liter engine
+ 6. System of start of the engine
+ 7. Ignition system
+ 8. Coupling
+ 9. Transmissions
+ 10. Main transfer, semi-axes
+ 11. Brake system
+ 12. Suspension bracket and steering
+ 13. Body
+ 14. Body electric equipment

5.2.7. Check and adjustment of the maximum turns

GENERAL INFORMATION

The maximum turns of the engine are established by the ECU block and cannot be adjusted.

Start of the cold engine

Turns of idling and the moment of injection of fuel are defined by the ECU block.

Adjustment

PERFORMANCE ORDER

1. Warm up the engine to working temperature, check turns of idling and cool the engine.

2. On the cold engine check a gap between the screw of adjustment and a control lever of the fuel pump. At temperature of cooling liquid 20 ° About a gap should be in limits from 0,8 to 1,1 mm.

3. For adjustment of a gap weaken a lock-nut and, rotating the adjusting screw, establish a demanded gap then establish a lock-nut.

4. Start the engine and check idling turns. If turns of idling differ from demanded, weaken a lock-nut and, rotating the adjusting screw, establish demanded turns then tighten a lock-nut.

5. Warm up the engine and check idling turns. In the course of engine warming up the gap between the adjusting screw and a control lever of the fuel pump should decrease gradually before complete contact of the screw to the lever. Otherwise there is a damage to system of cold start of the engine, and it is necessary to make repair at a maintenance stage.