Opel Omega - 1. Maintenance instruction + 1.1. Dashboard 1.2. Car opening 1.3. Rear-view mirrors 1.4. Ignition / starter switch 1.5. Manual transmission 1.6. Automatic transmission 1.7. Engine start 1.8. Release of the hand brake 1.9. Car parking 1.10. Multipurpose display 1.11. Electronic central air of air 1.12. Safety locks 1.13. Lighting 1.14. Lubricants and liquids 1.15. Impellent compartment + 1.16. Good advice + 2. Maintenance + 3. Repair of engines + 4. Heating system and ventilation + 5. Fuel, exhaust systems + 6. System of start of the engine + 7. Ignition system + 8. Coupling + 9. Transmissions + 10. Main transfer, semi-axes + 11. Brake system + 12. Suspension bracket and steering + 13. Body + 14. Body electric equipment
|
System of ellipsoidny forward headlights
|
1. Passing beam
2. Driving beam |
PERFORMANCE ORDER |
1. Remove a protective cover of a headlight |
|
2. Disconnect the socket from the lamp basis, take out a lamp clamp from a clip and turn it outside. |
|
3. To Vytolknita a lamp on the holder down also take out from the reflector case. |
|
4. Disconnect the holder from the lamp basis. |
|
System of xenon forward headlights
|
1. Passing beam
2. Driving beam |
PERFORMANCE ORDER |
|
1. To Vytolknita a lamp on the holder down also take out from the reflector case. |
|
2. Disconnect the holder from the lamp basis. |
|
Lay lamp
Forward index of turn
Fog lights
PERFORMANCE ORDER |
|
1. Weaken screws on the panel near fog lights, using a screw-driver, and remove the panel. |
2. Remove the screw on outer side of a fog light, turn a headlight aside and remove it. |
|
3. Remove a protective cover behind, having turned it. |
4. Disconnect the holder from a lamp socle. |
|
5. Release a latch of a lamp and turn down. |
6. Remove a lamp from the holder. |
|
7. Insert a new lamp so that the ledge on the holder of a lamp entered into dredging in a reflector. |
|
Stoplights, turn indexes, backing lamps, back antifog lamp
PERFORMANCE ORDER |
|
1. Press a uvula of the holder in the middle of the block of lamps aside and remove the block of lamps. |
|
2. Press uvulas of holders on the right and at the left the block of lamps to each other and remove the block of lamps. |
|
3. Press a clamp uvula on the block of lamps and remove the block of lamps. |
|
Lamp of illumination of registration plate
PERFORMANCE ORDER |
|
1. Press a spring clamp on one party and take out the holder of lamps, having extended it down. |
|
2. Press a uvula on the opposite side and open the lamp case. |
|
3. Turn out two screws in a reverse side of the handle of a door of a back. Take out a lamp. |
|
Lamp of illumination of salon (joining when opening door)
Lamps for reading (back)
|
|