Opel Omega

since 1993-1999 of release

Repair and car operation

Opel Omega
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Repair of engines
+ 4. Heating system and ventilation
+ 5. Fuel, exhaust systems
- 6. System of start of the engine
   6.1. Technical characteristics
   6.2. Search of a source of malfunction in electric equipment system
   6.3. Accumulator
   6.4. System of additional charge of the accumulator
   6.5. Connection of the auxiliary accumulator
   6.6. Driving belt of the generator
   6.7. Generator
   6.8. System of start of the engine
   6.9. Starter
   6.10. Ignition lock
   6.11. Switch of an alarm bulb of low pressure of oil
   6.12. Sensor of level of oil
+ 7. Ignition system
+ 8. Coupling
+ 9. Transmissions
+ 10. Main transfer, semi-axes
+ 11. Brake system
+ 12. Suspension bracket and steering
+ 13. Body
+ 14. Body electric equipment

6.3. Accumulator

Removal

PERFORMANCE ORDER

1. The accumulator is located on the left side of an impellent compartment.
2. Disconnect a wire of the minus plug.
	3. Remove a casing of burned-through crossing points if it is necessary and disconnect the plusovy plug of the accumulator.
4. Turn off a bolt and remove a fixing clip of the accumulator. Remove the accumulator from the car.

Installation

Installation is carried out to sequences, return to removal. Grease with technical vaseline of the plug of the accumulator before connection of wires.

THE ORDINARY ACCUMULATOR AND THE ACCUMULATOR DEMANDING SMALL MAINTENANCE

Check

It is recommended to check specific density of electrolit each three months for battery charging definition.

	Air temperature is higher 25 ° With	Air temperature is lower 25 ° With
The accumulator is completely charged	1,210-1,230	1,270-1,290
The accumulator is charged for 70 %	1,170-1,190	1,230-1,250
The accumulator is discharged	1,050-1,070	1,110-1,130

Check electrolit density in each section of the accumulator. If the specific density of electrolit between sections differs more, than on 0,040, it is necessary to replace the accumulator.

THE ACCUMULATOR WHICH IS NOT DEMANDING MAINTENANCE

Check

PERFORMANCE ORDER

The accumulator does not demand a dolivka of electrolit and check of its density. For check of a condition of the accumulator the indicator serves.

THE ORDINARY ACCUMULATOR AND THE ACCUMULATOR DEMANDING SMALL MAINTENANCE

Charging

At a battery charging the temperature of electrolit should not exceed 37,8 ° Page.

PERFORMANCE ORDER

1. Force of a charging current should make 3,5–4 Amperes. To continue a charging it is necessary until the specific density of electrolit will not raise within 4 hours.

2. Also for a battery charging it is possible to use the charger for continuous additional charge of the accumulator with a current of a charging of 1,5 Amperes. It is possible to leave such charger included for the night.

THE ACCUMULATOR WHICH IS NOT DEMANDING MAINTENANCE

Charging

The charging of this type of accumulators demands more time, than a charging of ordinary accumulators. The charging is necessary for carrying out at tension to 13,9–14,9 Volts, the current of a charging should not exceed 25 Amperes.